enlarge l dimensions

Victoria 5

The Victoria 5 is very flexible and completely modular in design.

It is simple and reliable and can be fitted with all models of lamphouses or attached to the CC7040H console with bulbs from 500W to 10000W.

Spools of 1800m. (6000 ft.) or 3000m. (10000 ft.) capacity can be mounted on the VIC 5 or the projector can be used with a platter film transport system.

enlarge l dimensions

Victoria 8

The Victoria 8/T version has the new sheet metal pedestal or can be fitted to the front of a CC7040H console.

The Victoria 8/T can have 1800 m. spools and upon request 3000 m. spools, or be run with a platter system.

The Victoria 8/T can use any of the three Victoria 8 mechanisms: Victoria 8-R, Victoria 8-35, Victoria 8-35/70. The Victoria 8-35/70 can run 70mm film with the use of a second projector or a film transport system.

enlarge l dimensions

CNR 3-35 platter system

The CNR 3-35 is a simple and reliable unit with all the best features. The platters are easily removeable for service.

Pay out unit is easily removable to assist in film movements. Proportional electronic speed control makes sure that the film movement is always accurate and smooth.

Totally independant take up and pay out with automatic level selection for take up and pay out.

The 5 tier units can be used to run two indeopendant cinemas at once with an additional kit.

enlarge l dimensions

Motorised film rewinder

Cinemecannica motorised film rewinder capable of handling 2000, 4000 and 5000 metre spools. The motor system allows for very accurate and responsive control of the rewind speed.

The following options are available: - automatic rewind shut-off and hand crank for manual operation. It is so possible to prepare a programme as required in automatic installations, spotting and removing all cues left over from a previous show in such a way not to have wrong automation operation.

The unit can rewind 5000 metres of film in less than ten minutes.

enlarge l dimensions

Xenon console CC7040H

The Cinemeccanica Xenon console can run lamps from 1600 watts through to 10,000 watts. A beam spreader can be fitted as an option for 70-mm film.

The rectifier is built into the base of the console for easy wiring and installation. Space is provided to install sound equipment and automation into the console if required.